HITEC ECLIPSE 7 User Manual

Aircraft
(ACRO)
Section
– 23 –
Model Setup Functions
This section describes the model setup functions that are used to choose all of the
operating features of a particular model memory. These functions are used to select the
model memory, the model type (from airplanes, gliders, and helicopters), set the
stopwatch, and other useful functions. These functions are used to set up a new model or
a new model memory, to switch between memories, and to change transmit shift..
Map of Basic Menu Functions...............(see right)
M.SEL..... Model select .......................................24
COPY ....... Data Copy ..........................................24
ACRO ....... Acrobatic model mode .......................25
HELI ....... Helicopter model mode ......................25
GLID ....... Glider model mode.............................25
2WNG ....... Two Servo Wing (GLID only)............26
4WNG ....... Four Servo Wing (GLID only) ...........26
NOR.......... Normal swashplate (HELI only) ........26
120’ ....... 120’Swashplate (HELI only)..............26
180’ ....... 180’Swashplate (HELI only)..............26
**** ....... Model Name (four letters +
up to three numbers) ..........................27
SFT.N..... Transmit Shift.....................................28
TIME ....... Timer setup.........................................29
REST ....... Reset Memory....................................29
Model Select [
M.SEL
]
Copy Model [
COPY
]
Model Name [
ABCD-199
]
Swashplate type (HELI only)
[
NOR
] [
120’
] [
180’
]
Timer Setup [
TIME XX
]
Reset Memory [
REST
]
Power On While Pressing
both Edit/Display keys
Shift Dir. [
SFT.N
] [
SFT.P
]
Model Type
[
ACRO
]
,
[
HELI
]
,
[
GLID
]
Wing Type (GLID only)
[
4WNG
], [
2WNG
]


HITEC ECLIPSE 7 Specifications

General

Brand	HITEC
Model	ECLIPSE 7
Category	Remote Control
Language	English