HITEC ECLIPSE 7 - Flap Mixing; Voltage;Timer Display Normal Display Mode; Press both Edit;Display Keys; End Point Adjust [ EPA]

Glider
(GLID)
Section
– 63 –
There are two different glider modes in the Eclipse 7
system. You set them up in the Model Setup menus (see
page 26). 4WNG refers to a glider with four wing servos.
2WNG refers to a model with two wing servos for flaperons,
but this setup also applies to models with an additional flap
or spoiler servo in CH6.
Glider Functions Map............................ (see right)
Glider Setup Example........................................ 65
EPA.............End point adjust ............................ 41
D/R.............Dual Rates..................................... 42
EXP.............Exponential................................... 43
FLT.C.........Flight Condition ............................ 44
STRM...........Subtrim.......................................... 47
REV.............Servo Reverse ............................... 47
PMX1-5.......Programmable Mixer #1– #5 ........ 49
ADIF...........Aileron Differential....................... 55
VTAL...........V-Tail............................................ 55
E->F...........Elevator
→ Flap mixing................. 52
A->R...........Rudder Coupling........................... 52
F->A...........Flap
→ Aileron mixing................... 72
F->E...........Flap
→ Elevator mixing................. 73
CROW...........Crow mixing (airbrakes) ............... 73
AIL.T.........Aileron Dual Trim......................... 77
S.TM1, 2....Speed Flap trim offsets 1, 2 (GLID4) 75
A->F...........Aileron
→ Flap mixing (GLID4) ... 77
DFL.T.........Dual Flap Trim knob (GLID4)...... 78
Glider Trimming Chart....................................... 81
Useful Control & Switch Information
Gear Switch controls receiver CH3
VR1 controls camber (flap motions)
VR2 controls receiver CH7 and sets DFL.T
CH7 switch Forward = F->A On, F->E On
GEAR switch Back = CROW Off,
Flt. Condition switch Back= A->F Off
Flt. Mode switch Back (“speed”)= E->F On, S.TM1
Flt. Mode switch Forward (“launch”) = S.TM2 On
Dual Rate Set
[D/R]
End Point Adjust
[EPA]
Normal Display Mode
Press both
Edit/Display keys
Prog. Mix 1
[PMX1]
through
Prog. Mix 5
[PMX5]
Flight Cond.
[FLT.C]
Exponential
[EXP]
Sub-Trims
[STRM]
Servo Reversing
[REV]
Voltage/Timer Display
Ail
→
Rud Mix
[A-R]
Crow Mix
[CROW]
Elev
→
Flap Mix
[E-F]
Ail Differential
[ADIF]
V-Tail
[VTAL]
Flap
→
Ail Mix
[F-A]
Flap
→
Ele Mix
[F-E]
Subtrim Set 1
[STM1]
Subtrim Set 2
[STM2]
Aileron Trim
[AIL.T]
Ail
→
Flap Mix
[A-F]
Dual Flap Trim
[DFLT]
4
4
4
4
4=4WNG only