HITEC ECLIPSE 7 User Manual

Helicopter
(HELI)
Section
– –
96
Hovering Throttle Adjustment Knob
The Hovering Throttle knob may be used to "tweak"
the throttle servo's position around hover without
affecting main rotor pitch. It’s handy to make up for
changes in rotor speed caused by variations in
temperature, humidity, or other conditions. To change
the hovering throttle setting, simply turn the Hovering
throttle knob VR1. As shown in the figure, turning the
knob has the largest effect in the hovering region and
leaves the endpoints alone. Please center this knob
before you set neutrals or input throttle curves.
Throttle Stick Motion
Throttle
Servo Response
Changing the
HV-T value
moves the
throttle response
above or below
the straight line
Low
High
Idle
Full
Pwr
Hover
Hovering Pitch Adjustment Knob
The Hovering Pitch knob may be used to trim the
collective pitch near hover without affecting throttle.
Like hovering throttle, it’s handy to make up for
changes in rotor speed caused by variations in
temperature, humidity, or other conditions. You can
adjust the hovering pitch value simply by turning the
Hovering pitch knob VR2. Like hovering throttle, this
knob only works near hover and tapers off at either end
of throttle. Please center this knob before you set
neutrals or input throttle curves.
Throttle Stick Motion
Collective Pitch
Servo Response
Changing the
Hovering Pitch
value moves the
pitch response
above or below
the straight line
Low
High
Min
Pitch
Max
Pitch
Hover

HITEC ECLIPSE 7 Specifications

General

Brand	HITEC
Model	ECLIPSE 7
Category	Remote Control
Language	English