Version 1.0, 11/2017. Copyright 2012 Hitron Technologies
18
Version 1.0, 11/2017. Copyright 2017 Hitron Technologies
18
Hitron E31N2V1 User’s Guide
Figure 6: GUI Overview
1.8 Resetting the E31N2V1
When you reset the E31N2V1 to its factory defaults, all user-configured settings are
lost, and the E31N2V1 is returned to its initial configuration state.
To reset the E31N2V1, press and hold the RESET button for ten seconds. The
E31N2V1 turns off and on again, using its factory default settings.
NOTE: Depending on your E31N2V1’s previous configuration, you may need to re-
configure your computer’s IP settings; see IP Address Setup on page 15.
Table 4: GUI Overview
Primary
Navigation Bar
Use this section to move from one part of the GUI to another.
Main Window Use this section to read information about your E31N2V1’s
configuration, and make configuration changes.
To Next Page
Loading...
