−11−
4. After Installation
(1) Reinstall any factory parts that were removed.
(2) Reconnect the negative terminal to the battery.
Another side of
Velcro Tape
One side of
Velcro Tape
To interior
Double-sided Tape
Controller Receiver
To interior
(Mounting Remote Controller) (Mounting Receiver)
Confirmation after installation
Check
Check
・Check the following after the installation process is complete.
(1)Check the following before starting the engine:
(2)Start the engine and check the following:
Check item
Make sure all wiring is done correctly.
Make sure all installed components do not come in contact with other parts.
Make sure harnesses are secured so that they do not disturb driving.
Make sure all removed factory parts are reinstalled.
Make sure the negative cable terminal is securely connected to the battery.
Make sure a battery is set to the remote controller.
Advice
・Do not raise the engine RPM right after starting the engine. Let it idle and warm up properly.
Check item
Make sure the installed parts are not hitting each other.
Make sure there is no excessive stress on harnesses.
Make sure there are no loose parts after the engine is stopped.
To Next Page
Loading...