To Next Page

To Previous Page

A2 VFD (0.75-30kW)

Pn 15 Startup DC braking voltage

：

1V—100V

By proper tuning of this parameter, motor can start

normally from fully stop state without any difficult caused

by motor’s free motion and rotate direction.

Pn 16 Startup DC braking time：000.00S—650.00S

DC braking time before motor startup to ensure that motor

is started from fully stop state.

Pn 17 Stop DC braking voltage

：

1V—100V

Braking voltage during DC braking period to ensure that

motor is fully stopped in brake time.

Pn 18 Stop DC braking time：000.00S—650.00S

DC braking time to prevent the slide move after stopping.

Pn 19 Source of multi-segment speed 0：1—5

Multi-segment speed mode 0-segment frequency source：

1 Potentiometer 2 Panel button

3 External 0-5V signal 4 External 0-10V signal

5 External 0-20mA signal

Pn 20 Multi-segment speed 1 frequency：000.10 Hz—400.00Hz

Multi-segment speed mode 1-segment frequency

Pn 21 Multi-segment speed 2 frequency：000.10 Hz—400.00Hz

Multi-segment speed mode 2-segment frequency

Pn 22 Multi-segment speed 3 frequency：000.10 Hz—400.00Hz

Multi-segment speed mode 3-segment frequency

Questions and Answers:

Need help?

Do you have a question about the HKS VFD Drive A2 Series and is the answer not in the manual?

HKS VFD Drive A2 Series Specifications

General