– 9 –
SLICING IN MANUAL MODE . . . without using the Presets (P1 – P4) or the Memory key
In Weight Mode . . .
Set the Tare, if needed.
Set thickness. Slice product.
The displayed weight will reflect the platter weight (less Tare, if NET was displayed).
When the product is removed from the platter, the display will return to 0.00 lb (or a negative weight will
reflect the Tare, if NET was displayed).
In Slice Mode . . .
Press the Mode key,
. Slice is displayed instead of the WEIGHT mode indicator, lb (or oz).
Set thickness. Slice product.
The display will count the number of slices. When the product is removed from the platter, press Clear,
, to reset the slice counter to zero.
The display can shift between
WEIGHT and SLICE modes by pressing the Mode key, , at any time.
SLICE AND WEIGH MORE THAN ONE ITEM
After slicing an item in weight mode, press Tare,
, to reset the weight back to zero without
removing the sliced product from the platter. Then, with the scale at 0.00 lb
NET, slice and weigh the
next item. Press Tare again and repeat. Make sure that the maximum Tare, 2 lb (1kg), and the scale's
total capacity, 6 lb (3 kg) are not exceeded.
FACTORY SETTINGS
The mode and value settings for P1, P2, P3, and P4 were preset at the factory. Separate memory slots
are provided for lb, oz, kg, and g settings.
FACTORY SETTINGS
P1 P2 P3 P4
MODE WEIGHT WEIGHT WEIGHT WEIGHT
0.25 lb 0.50 lb 0.75 lb 1.00 lb
4.0 oz 8.0 oz 12.0 oz 16.0 oz
Metric 0.115 kg 0.230 kg 0.340 kg 0.455 kg
115 g 230 g 340 g 455 g
METRIC CONVERSION
Portion scales equipped for pound and ounce weighing can be field converted for metric weighing
(kilogram and gram), or vice versa — by your service technician. A new bezel needs to be installed
in the control's display for this conversion.
To Next Page
Loading...
Need help?
General
