– 8 –
A NOTCH MUST BE ADDED TO BACKSPLASHES OVER
5-1/2" HIGH ON CORNER MACHINES TO PREVENT
INTERFERENCE WITH DOOR HANDLE. NOTCH MUST
EXTEND 6" FROM FACE OF THE MACHINE.
A splash shield kit is available (at extra cost) for corner installations to prevent
excessive splashing on wall. Order sales accessory CORNER-INST-AM16 or service kit
part number 00-562156-00001. For installation, refer to 0F-45885 installation instructions
supplied with kit.
For corner installations, tabling with backsplashes over 5-1/2" high require that a notch be
provided to prevent interference with the door handle (Fig. 7).
Fig. 7
PLUMBING CONNECTIONS
Plumbing connections must comply with applicable sanitary, safety
and plumbing codes.
Water Requirements
Proper water quality can improve ware washing performance by reducing spotting, enhancing
effectiveness of labor and extending equipment life. Water conditions vary from one location
to another. The recommended proper water treatment for effective and efcient use of this
equipment will also vary depending on the local water conditions. Ask your municipal water
supplier for details about local water conditions prior to installation.
Recommended water hardness is 3 grains of hardness per gallon or less. Higher hardness
may cause excessive formation of lime scale. Water hardness above 3 grains per gallon
requires water treatment. Water treatment has been shown to reduce costs associated with
machine cleaning, reduce deliming of the dishwasher and reduce detergent usage in the
dishwasher. Chlorides must not exceed 50 ppm.
To Next Page
Loading...
Need help?
General
