BA-21426-002-EN 06.08.2010 23
EN
11.1. POOR WASH RESULT
TYPE OF FAILURE POSSIBLE CAUSE REMEDY
Dishes are not clean. Wash arms stiff (you should be able to turn them
easily by hand).
Take out wash arms and clean them thoroughly.
Check water outlet from machine to wash arms
is clear.
Wash arm nozzles are clogged (visual check). Take out wash arm, remove cleaning cap and
rinse wash arm thoroughly until soil is removed.
Replace correctly.
Rinse arm nozzles are clogged
(possibly by lime deposit).
Remove rinse arms and decalcify them in sepa-
rate container.
Detergent concentration is too low or too high. Check setting of detergent concentration.
Coarse strainer soiled. Take out strainer, empty and clean it.
Fine strainer soiled or obstructed by lime. Take out fine strainer. If heavily soiled soak in a
vinegar solution. Then clean it thoroughly until the
pores are free.
Cleaning is to be done daily (see operating
instructions).
Wrong program selected for heavily soiled
dishes.
Select program with longer wash cycle.
Dishes or glasses do not
dry properly.
Rinse aid concentration too low. Increase concentration (see instructions).
Dishes still greasy. Detergent concentration too low: increase
(see instructions).
Check if detergent is appropriate. If not, choose
a stronger one.
Drain soiled water and refill machine.
Check pre-scrapping procedure.
Rack is not suitable for type of dishes (sloping). Use appropriate racks to create a sloping
position which allows water to drain away from
cavities.
Dishes stay too long in the machine at the end of
program.
Take out dishes as soon as cycle is completed to
enable them to dry.
11. TROUBLESHOOTING GUIDE
To Next Page
Loading...
