Hobart FP Series - User Manual

Questions and Answers

C
Christine MartinJul 31, 2025
How to fix dishes that are not clean after using Hobart FP?
- E
  Erica DayJul 31, 2025
  If your Hobart Dishwasher isn't cleaning dishes effectively, here are some potential causes and solutions: * Stiff wash arms: Remove and thoroughly clean the wash arms. Also, ensure the water outlet from the machine to the wash arms is clear. * Clogged wash arm nozzles: Take out the wash arm, remove the cleaning cap, and thoroughly rinse the wash arm until all soil is removed. Then, replace it correctly. * Clogged rinse arm nozzles: Remove the rinse arms and decalcify them in a separate container. * Incorrect detergent concentration: Verify the detergent concentration setting, consulting the operating instructions. * Soiled coarse strainer: Remove, empty, and clean the coarse strainer.
J
James HarrisonAug 5, 2025
Why don't dishes dry properly in my Hobart FP?
- E
  Elizabeth KramerAug 5, 2025
  If your Hobart Dishwasher leaves dishes not properly dried, consider these potential causes: * Low rinse aid concentration: Increase the concentration as per the instructions. * Greasy dishes: Increase detergent concentration, ensure you're using an appropriate detergent, drain the soiled water, refill the machine, and check your pre-scrapping procedure. * Unsuitable rack: Use appropriate racks to ensure a sloping position, allowing water to drain from cavities. * Leaving dishes too long: Remove dishes immediately after the cycle to facilitate drying.
G
gwattsAug 10, 2025
What to do if my Hobart FP leaves stripes and stains on dishes and glasses?
- H
  Henry SullivanAug 10, 2025
  If your Hobart Dishwasher leaves stripes and stains on dishes or glasses, consider these possible causes: * Rinse aid concentration too high: Reduce the quantity as per the instructions. * Hard water or high mineral content: Check your water quality with your local water authority. Ideal hardness is 4° Clark. Ideal conductivity is max. 150 µS/cm for glasses and max. 400 µS/cm for dishes. * Unsuitable rack: Use appropriate racks to ensure a sloping position, allowing water to drain away from cavities. * Insufficient rinse aid concentration: Increase the quantity as per the instructions. * Wrong salt type: If your machine has a softener, use only granular regeneration salt.
C
Christopher McdanielAug 15, 2025
Why does my Hobart Dishwasher suddenly stop during the wash program?
- B
  Brent WestAug 15, 2025
  If your Hobart Dishwasher stops suddenly during a wash program, it could be due to: * Connection to a maximum power supply unit: Connect the machine separately by calling an electrician. * Blown site fuse: Check the site fuses.
J
Jermaine MeyerAug 20, 2025
How to prevent glass breakages in Hobart Dishwasher?
- D
  danny82Aug 20, 2025
  To address glass breakages in your Hobart Dishwasher, use appropriate racks designed for dishes and glasses.
J
jennifer10Aug 25, 2025
Why are glasses totally or partially cloudy after washing in my Hobart FP?
- K
  Kara ZamoraAug 26, 2025
  This issue isn't due to a machine malfunction. The cloudiness, known as glass corrosion, indicates the surface of the glasses is rough and porous. The solution is to replace the affected glasses.