EasyManua.ls Logo

Hobart FP Series - Dryer Activation;Deactivation; Troubleshooting Guide

Hobart FP Series
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 21637-A-03-09
DE
GB
F
NL
12 TROUBLESHOOTING GUIDE
TYPE OF FAILURE POSSIBLE CAUSE REMEDY
Poor wash result
Dishes are not clean. Wash arms stiff (you should be able to
turn them easily by hand).
Take out wash arms and clean them thoroughly.
Check water outlet from machine to wash arms is
clear.
Wash arm nozzles are clogged
(visual check).
Take out wash arm, remove cleaning cap and rinse
wash arm thoroughly until soil is removed.
Replace correctly.
Rinse arm nozzles are clogged
(possibly by lime deposit)
Remove rinse arms and decalcify them in separate
container.
Detergent concentration is too low or too
high.
Check setting of detergent concentration.
See also operating instructions point 9.1.
Coarse strainer soiled. Take out strainer, empty and clean it.
In case of frost or longer operation pauses (e.g. for seasonal operations)
the machine must be completely drained.
This should be carried out by after sales service.
Reset for operation according to chapter 4.
For trouble free operation we recommend you enter into a service
contract with your local Service Office.
10 FROST PREVENTION
11 MAINTENANCE
9.8 ACTIVATION / DEACTIVATION OF DRYER
Push Program button
again until "drY" is displayed.
By pushing the ON/OFF button
automatic drying can be activated /
deactivated.
The lower Display
shows "On" (activated) or "0FF" (deactivated).
9.9 TERMINATION OF SETTING MODE / COUNTER DISPLAY
Open the door and close it again or do not press any button for
10 seconds.
SETTINGS AND COUNTER VALUES

Related product manuals