21637-A-03-09 7
DE
GB
F
NL
4.1 DETERGENT
Do not use any acidic detergent products with the built-in detergent
pump! (The ph-value has to be higher than 7.)
Place the suction hose into the detergent container.
Fill the suction hose according to chapter 4.3.
The dosing pump can operate to a max. head height of 1.5 m.
Machines with integrated detergent container (option)
:
Open the container and fill it with detergent up to the marking "MAX"
by using a funnel. Do not overfill the container!
4.2 RINSE AID
Open the drawer and fill the integrated reservoir with rinse aid up to the
marking "MAX".
Use only commercial detergent and rinse aid. Please pay
attention to the manufacturers safety instructions.
4.3 PRIMING THE SUCTION HOSES
ATTENTION:
The machine has to be switched off.
Open the door.
Push Stop button
➃
and Program button
➁
simultaneously until the
upper Display
➅
shows "CH1" and the lower one
➄
"8.0".
Push Program button repeatedly, until "d" and "0" is displayed.
Close the door.
In the upper Display appears "SF1", in the lower one "0".
4.3.1
DETERGENT SUCTION HOSE
Pushing the ON/OFF button
➀
activates the hose priming for 60 seconds.
Each cycle can be interrupted by pushing the ON/OFF button again.
4.3.2
RINSE AID SUCTION HOSE
(Only after retrofitting for external rinse aid.)
Push the Program button
➁
.
In the upper Display
➅
appears "SF2", in the lower one
➄
"0".
Pushing the ON/OFF button
➀
activates the hose priming for 80
seconds. Each cycle can be interrupted by pushing the ON/OFF button
again.
4.3.3 TERMINATION OF HOSE PRIMING
Open door and close it again or do not press any button for
10 seconds.
–
–
–
–
–
–
–
–
–
–
–
–
4 START-UP
To Next Page
Loading...
