ELECTRICAL CONNECTIONS (Cord Connected Mixers)
WARNING: THE ELECTRICAL CORD ON THIS MACHINE IS EQUIPPED WITH A THREE-
PRONGED GROUNDING PLUG WHICH MUST BE CONNECTED TO A PROPERLY GROUNDED
RECEPTACLE. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN
ELECTRICIAN. DO NOT REMOVE THE GROUNDING PRONG FROM THE PLUG.
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTION OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
Check Initial Operation
1. Apply power to the mixer by inserting the cord plug into a properly grounded outlet.
2. Install the bowl and raise into mix position, with the bowl support up and bowl guard wire
cage closed.
3. Turn the SPEED dial pointer to STIR.
4. Momentarily run the machine by pushing the START and then STOP buttons.
4
The electrical cord on this machine is equipped with a three-pronged
ELECTRICAL CONNECTIONS (Cord Connected Mixers)
Electrical and grounding connections must comply with the applicable por-
4
grounding plug which must be connected to a properly grounded receptacle. If the
receptacle is not the proper grounding type, contact an electrician. Do Not remove the
grounding prong from the plug.
tion of the national electrical code and/or other local electrical codes.
HL200 Mixer Technical Manual Page 10 of 111
To Next Page
Loading...
Need help?
General
