– 16 –
Using the Count-Down Mode (Timed Mixing)
1. Turn the SPEED dial to select a mix speed.
a. If the count-up mode was used for the previous batch, the desired time needs to be entered.
b. If the count-down mode was used for the previous batch, the previous time is displayed. If a
dierent time is needed, turn the TIME selector to the desired time.
2. Press the START button to begin mixing; the timer starts counting down from the set time.
a. To stop the mixer at any time, press the STOP button. To resume mixing, press the START
button. For example: The mixer is started at SPEED 1 for 30 seconds and is stopped after
10 seconds. Pressing the START button will resume mixing.
b. If the mixer is stopped and a new time setting is entered, pressing the START button saves
the new time setting on the current speed selection. For example: The mixer is started at
SPEED 1 for 30 seconds and is stopped after 10 seconds. A new time is entered by turn-
ing the TIME selector. The new time replaces the initial 30 seconds for SPEED 1 after the
START button is pressed.
c. If the time is changed while mixing, the mixer operates until the new time expires. The ad-
justment to the time is not stored.
d. If the speed is changed while mixing, the time reverts to the previously set time for the se-
lected speed and counts down.
The agitator does not stop immediately. To avoid risk of serious injury, keep
hands, clothing, and utensils out of the mixing bowl and away from the agitator as the agitator
winds down.
If the wire cage is opened at any time, the mixing stops. To resume the mixing, close the wire
cage and press the START button.
3. When the timer reaches 00:00, the mixer stops; a beeper sounds for 3 seconds. The count-down
timer displays the last-entered time.
OPERATING NOTES
• Only use STIR for incorporating ingredients. Do not use it to develop dough products.
• If the mixer is stopped during mixing, the timer also stops. The timer starts again (with the time
remaining) when the START button is pressed.
• The SPEED window displays the current SPEED selection.
• Turn the TIME selector clockwise to take the mixer out of the hold mode.
To Next Page
Loading...
