– 15 –
PREPARE FOR MIXING
1. Open the wire cage. Refer to the Wire Cage section as
needed.
2. Place the mixing bowl on the bowl support.
3. Pour ingredients into the bowl.
4. Swing the bowl to the locked position.
5. Place the agitator inside the bowl, then attach it to the
agitator shaft (Fig. 12).
6. Return the wire cage to the front-center position
(Fig. 13).
7. Push and hold the up arrow on the bowl switch until the
bowl reaches the mix position and stops.
8. The mixer is now ready for mixing. Refer to the Timer
Operation section.
TIMER OPERATION (SmartTimer™)
Using the Count-Up Mode (Continuous Mixing)
1. Turn the SPEED dial to select a mix speed (the SPEED setting can be changed at any time dur-
ing mixing).
Only use STIR for incorporating ingredients. Do not use to develop dough products.
2. Set the timer on hold by turning the TIME selector counterclockwise until "Hold" appears in the
TIME window.
3. Press the START button to begin mixing. The timer starts to count up from 00:00.
If the wire cage is opened at any time, mixing stops. To resume mixing, close the wire cage
and press the START button.
4. Press the STOP button to stop the mixer; the mixing time is displayed in the TIME window.
5. Press the START button to resume mixing if needed.
When the timer reaches 20:00 minutes, it rolls over to 00:01 and continues counting until the
STOP button is pressed.
Fig. 12
To Next Page
Loading...
