– 21 –
Transmission
To check the oil level, remove the top cover, which is secured by two screws. Remove the Transmission
Fill Plug (Fig. 16) and check the oil level. If the oil level is below the line on the oil dipstick, add a small
amount of the recommended transmission oil until it returns to the proper level. Do not overll the
transmission, as leakage may result. Contact your local Hobart Service Oce for the recommended
transmission oil.
Fig. 16
TRANSMISSION BELT
The transmission belt should be inspected yearly for wear and replace by a Hobart Service Technician if
worn.
ADJUSTMENTS
Agitator Clearance
The agitator clearance should be checked periodically. The agitator must not touch the bowl, and the
maximum clearance between the bottom of the bowl and an agitator is:
Agitator Models Max Clearance
B Flat Beater HL600, HL600C, HL800, HL800C, HL1400, HL1400C 1/8" (3 mm)
ED Dough Arm
HL600, HL600C, HL800, HL800C 5/16" (8 mm)
HL1400, HL1400C 11/16" (17 mm)
Install a bowl and agitator (e.g., beater). If the bowl and beater come into contact before the bowl support
reaches its stop, adjust the stop screw. Refer to the Adjust the Bowl/Agitator Clearance section.
To Next Page
Loading...
