Hobbico NexSTAR EP User Manual

Hobbico
®
Model Manufacturing Co. guarantees this kit to be
free from defects in both material and workmanship at the date
of purchase. This warranty does not cover any component parts
damaged by use or modifi cation. In no case shall Hobbico’s
liability exceed the original cost of the purchased kit. Further,
Hobbico reserves the right to change or modify this warranty
without notice.
In that Hobbico has no control over the fi nal assembly or material
used for fi nal assembly, no liability shall be assumed nor accepted
for any damage resulting from the use by the user of the fi nal
user-assembled product. By the act of using the user-assembled
product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated
with the use of this product, the buyer is advised to return
this kit immediately in new and unused condition to the place
of purchase.
To make a warranty claim send the defective part or item to Hobby
Services at the address below:
Hobby Services
3002 N. Apollo Dr., Suite 1
Champaign, IL 61822 USA
Include a letter stating your name, return shipping address, as
much contact information as possible (daytime telephone number,
fax number, e-mail address), a detailed description of the problem
and a photocopy of the purchase receipt. Upon receipt of the
package, the problem will be evaluated as quickly as possible.
READ THROUGH THIS MANUAL BEFORE
STARTING CONSTRUCTION. IT CONTAINS
IMPORTANT INSTRUCTIONS AND WARNINGS
CONCERNING THE ASSEMBLY AND USE OF
THIS MODEL.
Champaign, Illinois
(217) 398-8970, Ext 5
E-mail: airsupport@hobbico.com
WARRANTY
INSTRUCTION MANUAL
Entire Contents © Copyright 2007 HCAA0935 for HCAA09** V1.0
Wingspan: 68.5 in [1740mm]
Wing Area: 722 sq in [46.6dm
2
]
RTF Weight: 7.0 – 8.5 lb [3175 – 3855g]
Wing Loading: 22 – 27 oz/sq ft [68 – 83g/dm
2
]
Length: 56 in [1410mm]
Motor: RimFire 42-50-800

Hobbico NexSTAR EP Specifications

General

Requires	4-Channel Radio System
Power System	Electric
Skill Level	Beginner
Construction	Balsa and Plywood
Type	Trainer
Radio	4-channel radio system

Summary

WARRANTY

INTRODUCTION

IMPORTANT SAFETY PRECAUTIONS

KIT INSPECTION

KIT CONTENTS

A GUIDE TO THE NEXSTAR EP SELECT FEATURES

Brushless Power System

Futaba® PA-2 Pilot Assist Link

ASSEMBLY

Charge the Batteries

Guidance on charging the transmitter, receiver, and motor batteries before assembly.

Assemble the Wing

Instructions for assembling the two wing halves, including rods and flaps.

Install the Landing Gear

Steps for installing the main landing gear legs into the fuselage.

Install the Tail Surfaces

Install the Motor Batteries

SET-UP

Center the Control Surfaces

Steps to ensure all control surfaces (ailerons, elevator, rudder) are centered correctly.

Check Control Surface Directions

Verification that each control surface moves in the correct direction corresponding to transmitter inputs.

Arming the Motor

Procedure for safely arming the motor and ESC for operation, including brake settings.

Check the Control Throws

Measurement and verification of the amount control surfaces move (throws) for optimal flight.

Balance the Model (C.G. - Center of Gravity)

Crucial steps to correctly balance the model at its center of gravity for stable flight.

Balance the Model Laterally

Setting Up the Futaba PA-2 Pilot Assist Link

Initial setup and connection of the PA-2 Pilot Assist Link module for flight stabilization.

Adjusting the PA-2 from Your Transmitter

FINAL PREPARATIONS

At-the-Shop Check List

FLIGHT PREPARATIONS

Check the Frequency

FLYING

Taxiing

Takeoff

Instructions for initiating a safe and controlled takeoff from the runway.

Flight

Advice on maintaining stable flight, adjusting trims, and practicing maneuvers.

Landing

Detailed instructions for executing safe and controlled landings.

AFTER YOU MASTER THE NEXSTAR EP SELECT IN ITS ORIGINAL FORM

Dual Aileron Servos

Flaperons

Dual Aileron Servos & Flaps

AMA SAFETY CODE (excerpts)

PRE-FLIGHT CHECK LIST