Hobbico AVISTAR 40 Select - User Manual

1610 Interstate Drive Champaign, IL 61822
(217) 398-8970, Ext. 2
airsupport@hobbico.com
READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANT
INSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL.
WARRANTY
Hobbico guarantees this kit to be free from defects in both material and workmanship at the date of purchase.This warranty does
not cover any component parts damaged by use or modification. In no case shall Hobbico’s liability exceed the original cost of
the purchased kit. Further, Hobbico reserves the right to change or modify this warranty without notice.
In that Hobbico has no control over the final assembly or material used for final assembly, no liability shall be assumed nor
accepted for any damage resulting from the use by the user of the final user-assembled product. By the act of using the user-
assembled product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised to return
this kit immediately in new and unused condition to the place of purchase.
HCAZ3039 for HCAA16** Ver 1.0 © Copyright 2002
®
See more of our products at www.hobbico.com

Summary

Critical Safety and Operational Guidance

Important Safety Precautions

PART I: ASSEMBLY

Wing Assembly Steps

Fuselage Assembly Steps

Control Linkage Assembly

Propeller and Spinner Mounting

Final Assembly Caution

PART II: SETUP

Verify Control Directions

Connect servo, turn on transmitter/receiver, check control stick movements for correct response.

Center Flight Controls

Center elevator, rudder, and ailerons by adjusting trims and pushrods for neutral position.

Adjust Throttle Settings

Set throttle for closed carburetor (idle) with stick down and fully open with stick up.

Set Control Throws

Adjust Elevator Throws

Measure elevator up/down movement (3/8" to 7/16") and adjust pushrods if needed.

Adjust Aileron and Rudder Throws

Measure and adjust aileron and rudder throws to recommended specifications.

Balance the Model (CG Check)

Center of Gravity (CG) Procedure

Mark wing balance range, lift model to check C.G., and add weight if necessary.

Final Pre-Flight Checklist

Review a checklist of essential items before taking the model to the flying field.

PART III: FLIGHT PREPARATION

Pre-Flight Control Check

Radio Range Check Procedure

Perform a radio range check to ensure adequate operational range and detect malfunctions.

PART IV: FLYING

Taxiing Procedure

Takeoff Instructions

Flight Maneuvering

Landing Procedure

Steps for performing a controlled landing, bleeding altitude, and touching down gently.

Maintenance Tips

Hobbico AVISTAR 40 Select Specifications

General

Brand	Hobbico
Model	AVISTAR 40 Select
Category	Toy
Language	English