Hobby King TRAINSTAR - Control System Instruction; Bind the Receiver

2.4G Control System Instruction
Bind the receiver:
1.Turn the throttle to the bottom.
2.Turn on the transmitter.
3.Connect the battery of the receiver.
4.Push the code switch of the receiver. (the LED of the receiver will shine quickly)
5.The LED will light without interrupted. (means the code matching succesfully)
11
Rudder
Elevator
(↑↓)
(↑↓)
Motor trimmer
(← →) Rudder
Rudder trimmer
Aileron trimmer
Aileron
Rudder
Commingle control switch (it can
realize the mode transform of “V”
model triangle wing).The CH1
controls with the Ch2 passage mix
Motor
E levator
Aileron (← →)
Mode 2 (Right throttle)
Motor
Elevator
Aileron
ON
Elevator trimmer
Caution light of low power
Crystal
Transmitting antenna
Handle
Motor trimmer
(↑↓) Motor
Power LED
Power switch
Elevator (↑↓)
(← →) Rudder
Rudder trimmer
Motor
Commingle control switch (it can
realize the mode transform of “V”
model triangle wing).The CH2
controls with the Ch3 passage mix
Aileron trimmer
Aileron (← →)
Mode 1 (left throttle)
5
Precautions:
Pls make sure the throttle stick is on the down position then bind the reciever.
Before you connect the battery of the plane, pls leave away the propeller,
before the receiver bind the transmitter it may cause the propeller run automaticly.
Motor trimmer