Hobby King TRAINSTAR - Landing Procedures; Post-Flight and Warnings; After Flight Procedures; Flight Environment Warnings

Fly in spacious ground without obstacles and boscage.
FLIGHT WARNING
Landing
To land, fly down - wind past the landing area . Gently turn into the wind,
add flaps
and reduce the throttle so that the airplane initiates an ascending
glide path. If necessary, add power to extend the glide path to reach the
runway. As the model approaches and loses altitude, gradually and
proportionally add “ up ” elevator to control the glide path and altitude.
Continue to apply elevator until the mode l touches down at which time you
should be holding full , or nearly full up elevator. This will cause the airplane
to slow and settle to the ground.
Later,once you have become more experienced with your plane, you can
cruise around and perform slow “ fly-bys ” with the flaps extended.
Disconnect the battery and remove it from the airplane. Then, turn off the
transmitter. Allow the battery to cool before recharging, or allow the motor
to cool before installing another battery for the next flight. Inspect the
airplane to make sure nothing has become loose or damaged.
CAUTION: If, during a rough landing, the propeller becomes
jammed and cannot rotate, the battery andspeed control
will become very hot if you attempt to add power .
Immediately move the throttle down to stop the motor . If
you fail to do this, the motor, speedcontrol and/or battery
will be damaged.
AFTER FLIGHT
7
17