18
Jib kit
Shackle the two jib clew blocks to the jib clew plate
using the shackle provided.
10
Jib sheet line
Take the jib sheet (yellow) and tie one end to
the becket on one of the jib sheet blocks
using a bowline knot.
11
Take the other end of the sheet and pass it through
the corresponding jib clew block. Now pass the line
through the sheave, then the cam cleat on the jib
sheet block.
Pass the jib sheet behind the mast (but above the cunnin-
gham lines) and duplicate threading procedure on the
other side of the crossbar.
Take the end of the furler line and lead it through the fair-
lead and cam cleat on the front crossbar. Pulling the furler
line will furl the jib, provided that the jib sheet line is not
cleated.
NB : it is not advisable to leave the jib furled for extended
periods of time.
12
To Next Page
Loading...
Need help?
General
