22
Always wash traveller and blocks with fresh water after
use in salty water.
Always wear your Hobie buoyancy vest,
look out for overhead power lines
It is recommended that beach rollers be used to move
your Hobie FX-One. This will save your back and the
bottom of the boat.
Fit the daggerboards into the daggerboards wells. The
daggerboard roller shock cord should be tight enough
to prevent the daggerboard from slipping down.
Tension the rig. This can be accomplished by having
your assistant hang from the trapeze or you can use
mainsheet tension on one side at a time so that you
can adjust the shroud position in the side stay adjus-
ters.
Pre-sailing
Install the drain plugs – do not overtighten, hand tight is
sufficient. Overtightening may cause the drain plug
flange to distort and cause leakage.
1
2
3
4
5
To Next Page
Loading...
Need help?
General
