7
Tiller crossbar & tiller extensions
Insert the rudder pin, and do not forget to put in the
two split rings: one on top and one at the bottom of
the rudder pin.
Repeat the proce-
dure for the right
rudder
assembly.
Identify the right rudder from the left rudder (green sti-
cker = right ; red sticker = left)
Take the left rudder, position the washer as indicated on
the photograph, then align the rudder casting onto the
gud-
geon
.
1
2
3
Take the yoke connection of the tiller extension and fix it
into the middle of the tiller crossbar.
Take the tiller crossbar and insert the right side
into the right rudder arm and the left side into the
left rudder arm.
4
5
Then fix the tiller head into the yoke connection as
shown on the photo.
6
To Next Page
Loading...
Need help?
General
