Hobie Island - Hoisting and Terminating Halyard Line

12
10
Feed line through Mast
Tip Rotator from back-
side (end with the Tell
Tale Post) and out the
front. Pull the slack
through. (FIG 18)
Raise mast while hold-
ing onto the end of the
Halyard Line.
Terminate the end of the
line on the head of the
sail with a bowline knot.
(FIG 19)
Tie Bow Pulley Line end
to grommet on the tack
of the sail using a bow-
line knot. (FIG 20)
Fully hoist sail until it
hits the stopper knot
on the Bow Pulley Line.
Adjust the stopper knot
based on personal pref-
erence of how high you
would like the sail to be.
Note: A lower spinnaker
sail is slightly faster but
a higher sail increases
visibility under the sail.
Feeding the Halyard Line through the kit
From Aft Block
T
o
S
p
i
n
n
a
k
e
r
H
e
a
d
Spinnaker Head
Spinnaker Tack
FIG 18
FIG 19
FIG 20