Hobie iTrek User Manual

8
Inating & Deating
Your kayak comes with
two pumps.
The electric pump will
inate your kayak to
1 PSI Max. This is NOT
enough pressure to
use the kayak.
For higher pressure,
use the manual hand
pump.
Locate the air valve(s)
on your kayak near the
stern.
Unscrew the cover of
the valve and make
sure the pin is “up”.
If it does not spring
up it is in the “down”
position. To unlock the
pin from the “down”
position push down
on the pin and turn it
counterclockwise until
it pops up.
Line up the nozzle
of the pump with
the valve. Make sure
the pin is in the “up”
position. Plug in the
nozzle and 1/4 twist to
lock the nozzle to the
valve. Begin inating.
Inating the Kayak
1
2
3
Pin Single
Action
Double
Action
1 PSI Max
For higher
PSI
Pin Single
Action
Double
Action
1 PSI Max
For higher
PSI
Pin
Single
Action
Double
Action
1 PSI Max
For higher
PSI

Hobie iTrek Specifications

General

Type	Inflatable Kayak
Width	36 inches
Material	PVC
Hull Material	PVC
Seat Type	Inflatable
Storage	Bow storage