Hobie Mirage Outback User Manual

28
Fishfinder Option
Gasket
Run the Power Cable and Attach the Thru-Hull Plug
1
Run the power cable into
the hole for the 3-way
plug in the cockpit.
2
Choose the rubber
adapter for your wire
size and insert the
power cable by opening
the adapter along the
slit.
3
Press the rubber adapter
with the wire installed
into the plastic plug
housing, making sure it
fits snuggly.
4
Once all the cables are run
through the hull, fasten the
thru-hull wire assembly to
the hull. Hand-tighten the
screws on the 3-way plug.
Make sure the gasket is
properly installed. Take
caution to not overtighten
the screws.
NOTE: Rubber
adapters can be found
inside the Hobie kayak
owner’s manual.
TIP: Lubricate the cable
with soapy water to allow
it to slide through the
rubber plug more easily.

Hobie Mirage Outback Specifications

General

Drive System	MirageDrive 180 with Kick-Up Fins
Hull Construction	Rotomolded Polyethylene
Capacity	1 person
MirageDrive	MirageDrive 180 with Kick-Up Fins
Rod Holders	4
Width	34" / 0.86 m
Weight Capacity	425 lbs