34
To prevent industrial accidents, keep hands and other parts of the body as far as possible from the
tool arm when the table top is turning.
Fig. 19
Fig. 18
NOTE: Demounting and mounting are always done with the clockwise turntable rotation. Anticlockwise rotation
is used only to correct operator's errors or if the turntable stalls.
During rim locking NEVER keep your hands under the tyre. For a correct locking operation set the tyre
exactly in the middle of turntable.
During arm tilting make sure that nobody stays behind the tyre-changer
Never keep your hands onto the wheel: the arm recovery to “working position” could set the operator
at risk of hand crushing between rim and mounting tool.
To Next Page
Loading...
