EasyManuals Logo

HOLDEN VE Commodore II Series User Manual

HOLDEN VE Commodore II Series
340 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #287 background imageLoading...
Page #287 background image
Black plate (41,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
/
12
Vehicle Care 10-41
Tyre pressure low/very low
.
Low/Very low pressure(s)
flashes on the display if TPM is
selected.
.
Correct the tyre pressures as
soon as possible.
Note: The TPM warnings will
precede this display when selected.
Units conversion
The unit of measurement displayed
canbechangedfromkPatoPSI.
See Vehicle Personalisation on
page 537.
Note:
.
If the vehicle is equipped with
TPM, the spare wheel wi ll be
recognised on any of the four
wheels.
.
If the tyres are replaced, put
each wheel back on the same
axle that it was removed from.
TPM sensor relearn procedure
If one or more of the TPM sensors
are re plac ed or the vehiclestyres
are rotated, the identification codes
need to be matched to the new tyre/
wheel locations.
The sensors are matched to the
tyre/wheel locations in the following
order:
.
Passenger side front tyre, driver
side front tyre, driver side rear
tyre, passenger side rear tyre.
The TPM sensors are matched to
each tyre/wheel position by
increasing or decreasing the tyres
air pressure.
When increasing the tyres
pressure, do not exceed the
maximum inflation pressure. See
Tyre placard under Wheels and
Tyres on page 1037.
To decrease the tyres air pressure,
use the pointed end of the valve
cap, a pencil-style air pressure
gauge, or a key.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HOLDEN VE Commodore II Series and is the answer not in the manual?

HOLDEN VE Commodore II Series Specifications

General IconGeneral
BrandHOLDEN
ModelVE Commodore II Series
CategoryAutomobile
LanguageEnglish

Related product manuals