Holder C250 - Driving Mode with the Special Drive Sys; Tem

Operation C250 ... C370
108 Translation of Original Operating Manual 156319-04
Driving mode with the Special Drive Sys-
tem*
C270_060a
B
B
A
C
C270_077a
A
C
B
B
Switching on the SDS driving programme
1. Set the programme switch (A) to range 4.
ADVICE
In this range, the fine adjustment
wheel (C) is non-functional. Its func-
tion is taken over by the fine adjust-
ment control (B/4).
2. Adjust e required engine or PTO shaft speed
with the fine adjustment control (B/4).
3. Determine the driving speed from stationary
to maximum driving speed infinitely variably
with the throttle pedal (3).
* Optional equipment