10 of 20 11 of 20
Sequential Watering (continued)
® This will update to show
STARTS SYNCED when
the STARTTIMES
have been synced
® This will sync STARTTIMES
across both ZONES
for START 1 only
4. Check ZONE 2 to see
STARTTIMES are
automatically set [c]
5. Repeat steps 1-3 to set up
SEQUENTIAL WATERING
for STARTS 2-3 as desired
® SEQUENTIAL WATERING
does not apply to
CYCLE WATERING
Basic Functions Basic Functions
Sequential Watering
® SEQUENTIAL WATERING occurs when both ZONES are scheduled
to run at the same time / have the same DAY SELECTION
® Rather than running all of your ZONES at once,
the BX2 will automatically run each ZONE
one-by-one per your desired RUN TIMES
® Running multiple ZONES at once is not possible as this will
result in pressure loss across your irrigation system
1. Follow the instructions
as per the Scheduling
section of this manual to
set your watering routine
® STARTTIMES do not need
to be edited for ZONE 2 in
SEQUENTIAL WATERING,
this will be automatically
updated after set up
2. Once RUN TIMES are set
for both ZONES, tap ZONE1
on the ZONES page [a]
3. Next to START 1, tap
the STARTS NOT
SYNCED icon [b]
b
a
c
Our single outlet
BX1 Bluetooth
®
Tap
Timer is the perfect
companion to your
garden. Water all
around your home
with iGardener
®
.
Bluetooth Tap Timer
To Next Page
Loading...