12
PROGRAMMING
Continue until all the stations in Program1 have been set with a run time or if a
station(s) is not required to be active in this particular program, ensure that the run
time is set to “OFF”.
NOTE: To turn a station “OFF” press the
when the minutes are ashing, and
when the hours are ashing.
This completes the setting up procedure for automatic program 1.
Select from up to 3 programs using the
button for different watering schedules.
On every press of the
button the program number will increment. Once on the
desired number, follow the three steps to set an automated program:
1. Set start Times
2. Set Watering Days
3. Set Station Run Times
TIP: Although the controller will run automatic programs with the main dial in any
position (with the exception of “OFF”), it is advisable to leave the main dial in the
“AUTO” position when not programming or running manual stations or programs.
Step 3 - Station Run Times (cont.)
Press
or
button to select the station (valve) number, and press the
button and the run time minutes will ash. Alter by using
or
.
Press the
button and the run time hours will ash. Alter by using
or
.
Press the
button and the current station will ash. Select the next station to
change by using
or
and proceed by pressing and alter using
or .
To Next Page
Loading...
