16
Stop Watering
To stop an automatic or manual watering schedule, turn the dial to the “OFF”
position.
NOTE: For automatic watering remember to turn the dial back to the “Auto” position,
as “OFF” will stop any future watering cycles from occurring.
Stacking Start Times
Should you accidentally set the same watering start time on more than one program,
the controller will “stack” them in sequential order. All programmed start times will be
watered from the highest number rst.
Automatic Backup
This product is tted with permanent memory. This allows the controller to hold all
stowed values even in the absence of power sources, which means that programmed
information will never be lost. Fitting the 9 volt block battery is ideal for remote
programming and to show the display during power outages. However, if the battery
is not tted the real time clock is backed up with a Lithium coin battery that has been
factory tted. This means that when the power returns the clock will be restored to the
current time.
It is recommended that the 9V battery is tted and it is changed every 12 months.
A “Fault Bat” icon will show in the display when the battery has a week left to run.
When this occurs, replace the battery as soon as possible.
The 9V battery will show the display for 9 months without AC power and will go into
sleep mode after a minute if there is no AC power.
Note: If there is AC power the buttons will be responsive at all times.
In the sleep mode the clock will be shown but the dial/buttons will not be responsive
until
or are pushed to wake it up.
OTHER FEATURES
To Next Page
Loading...
