HOLUX GPSlim236 Wireless Bluetooth GPS Receiver Manual
16
7. Driver Installation
You can use any accessories data cable without installing driver
except GR230-A2 USB cable. The following is the steps of installation GR230-A2
USB cable.
7.1 System Requirement
CPU: IBM, Pentium, or other compatible PC.
Memory: above 16 MB
System: Windows 98/Me/2000/XP
7.2 Installation
I. Copy entire USB folder from CD to hard disk.
II. Connect GR-230-A2 USB connector to computer without GPS
receiver. While the computer automatically starts the installation program,
please direct the driver to the USB folder.
7.3 Important
Verify the COM port to start using your own navigation software.
I. Click <Start> menu, select → <Setting>, then enter→ <Controller>
II. After entering <Controller>, and select <System>.
III. Select <Device Manager>.
IV. Find the < Connector(COM & LPT)> and check the Virtual COM Port, which
was created by the USB driver.
Please note that the virtual COM port number might be different from every
computer. Before using navigation software, please confirm the COM Port numbers
created by your computer and provided by your navigation software. Otherwise, the
navigating software won’t receive the satellite signal, because of the un-match
COM Port setting.
To Next Page
Loading...
Need help?
General
