HOLUX
4. Switch on the Power
5. Bluetooth Link
Note about Bluetooth connection
When you power on the
, you need to wait 6 seconds for Bluetooth to self-test
before a connection is established. Wait until the Bluetooth light starts to flash ( once every
second). Then a Bluetooth- link can be established between a PDA and the
.
6. GPS Viewer
<Warning>
Do not place the
under strong sunlight for a long time. Do not place it in a
high-temperature environment, or near heat radiating devices such as a stove or
radiator. Doing so will cause the device to breakdown and to function unstably.
- For further information, please read the user’s manual in the supplied CD.
-
PASSKEY – 0000
(For security, some PDAs will prompt users for the
Passkey)
Slide the power switch to the ON position.
To operate link with a PDA (Personal Digital
Assistant): Activate the Bluetooth Manager, select
Search, and link.
Select the HOLUX
icon and choose SPP
slave to establish the Bluetooth link.
Refer to the “Software Installation” section for details i
you have any problem installing the Bluetooth link.
You can install the GPS viewer program from the
supplied CD to check current positioning and satellite
signal reception.
Activate the GPS Viewer, set the Baud Rate to 38400,
and press Scan for automatic scanning. Once you find
the correct Com Port, choose GPS Status to start
viewing.
Refer to the “Software Installation” section for details i
you have any difficulty with installation and use.
To Next Page
Loading...
Need help?
General
