Why Holux GPSport 245 GPS cannot display my current location?
If your Holux GPS isn't showing your current location, make sure that buildings or other obstructions are not interfering with the GPS signal.
What to do if my Holux GPS cannot start?
If your Holux GPS unit won't start, it might be due to insufficient battery charge. Connect it to the adapter and restart the system.
What to do if Holux GPSport 245 has no screen displayed?
If the screen on your Holux GPS isn't displaying anything, try these steps: * Connect the adapter and restart the system. * Perform a hard reset by pressing both the [Enter] and [right arrow] keys.
Why is the display speed too slow on my Holux GPSport 245?
If the display speed on your Holux GPS is too slow, it could be due to a low battery. Check if the battery is low on power. If that's not the issue, try a hard reset by pressing both the [Enter] and [right arrow] keys.
What to do if Holux GPS screen has no response?
If the screen on your Holux GPS is unresponsive, try a hard reset of the system by pressing both the [Enter] and [right arrow] keys.
General| Water Resistance | IPX7 |
|---|---|
| Chipset | SiRF Star III |
| Channels | 20 |
| Antenna | Built-in patch antenna |
| Update Rate | 1 Hz |
| Acquisition Time (Hot Start) | 1 second |
| Backlight | Yes |
| Data Logging | Yes |
| Interface | USB |
| Acquisition Time (Warm Start) | 35 seconds |
| Data Format | GPX |
| Battery | Lithium-ion |
To Next Page
