~ 4 ~
3 ELECTRONIC CONTROL INSTRUCTIONS
Before using the Treadmill:
3.1 Plug in the power, turn on the switch (switch is red) (1), please wait for the screen to light up and enter the start
interface.
3.2 Screen
3.2.1
Time:
Display the exercise time, the forward timing is from 0:00-99:59, and the count will be restarted
at 99:59; the countdown will decrement from the set time to zero, when the countdown reaches 0:00, the
treadmill will slow down and stop. Run, and enter the standby state after a complete stop.
3.2.2
Speed:
The current speed value is displayed in the running state, and the speed display range: 1.0-12 km/h. At
the start countdown, "3", "2", and "1" are displayed.
3.2.3
Distance:
Display the movement distance, the forward count is from 0.0-99.9, and the count will be re-counted
after overflow, and the reverse count will be decremented from the set value to zero. When the
countdown reaches 0, the treadmill will slow down and stop running, and enter the standby state after it
stops completely.
3.2.4
Calories:
Display the calorie consumption value. When the calorie consumption value is displayed, it will count
from 000-990 when counting forward, and then count again after overflow. When counting backward, it
will count down from the set value to 0. When the countdown reaches 0, the treadmill will drop steadily.
It stops running quickly and enters the standby state after a complete stop.
3.2.5
Mileage
Shows the accumulated mileage since the first start.
To Next Page
Loading...
Need help?
General
