12
ADJUSTING AIRFLOW DIRECTION
While the unit is on, press the SWING/DIRECT button on the remote control to set the vertical direction
Remote Control section on this manual for details.
Note:
• In COOL or DRY mode, do not set the louver at a vertical angle for too long. This will leave droplets
• In COOL or HEAT mode, setting the louver at a
vertical angle can reduce the performance of the
your preferred direction.
WARNING
• The manual button is only intended for testing
purposes and emergency operation. Do not use it unless
the remote control is lost and it is absolutely necessary
to utilize the manual button to operate the unit.
• Turn the unit off before any manual operation.
•
of the unit. The interior high-speed fan could hurt you.
• Do not move the louver by hand as it will cause the
louver to become out of sync with the remote control.
To reset the louver, turn the unit off and unplug it for a
few seconds, then restart it.
1. Open the front panel of the indoor unit.
2. Locate the MANUAL CONTROL button on the lower
3. Press the MANUAL CONTROL button to activate the
FORCED AUTO mode.
4. Press the MANUAL CONTROL button again to activate
5. Press the MANUAL CONTROL button once more to turn
the unit off.
6. Close the front panel.
To restore to regular operation, use the remote control to
activate the unit.
Deflector
Rod
Operating Instructions
Fig.B
Range
Manual Control
Button
To Next Page
Loading...
