28
Installation
Step 3: Drill a hole through the wall for
feeding the pipes outside.
1. Determine the location of the wall hole based
on the position of the mounting plate. Refer
to the Mounting Plate Dimensions.
2. Use a 2.5 inch or 3.54 inch (depending on
models ) core drill to drill a hole in the wall.
Make sure that the hole is drilled at a slightly
downward angle, so that the outdoor end
of the hole is lower than the indoor end by
about 0.2 to 0.275 inches. This will ensure
proper water drainage.
3. Place the protective wall cuffprotective wall cuff in the hole.
This protects the edges of the hole and will
process.
WARNING
When drilling the wall hole, make sure to avoid
wires, plumbing, and other sensitive components.
Wall
Indoor Outdoor
0.2-0.275 in
MOUNTING PLATE DIMENSIONS
Different models use different mounting plates. For
different customization requirements, the shape of
the mounting plate may be slightly different. The
installation dimensions, on the other hand, are the
same for the same size of indoor unit. See Type A
Note: When the gas side connective pipe is
Φ 5/8in or more, the wall hole should be 3.54in.
Correct Orientation of Mounting Plate
Type A
Type B
Left Rear Wall
Hole 2.5 in
Right Rear Wall
Hole 2.5 in
Indoor Unit
Outline
1.5 in
1.5 in
11.2 in
1.85 in
1.85 in
5.8 in
1.7 in
4.1 in
28 in
4.2 in5.1 in
9.3 in
15.8 in
9.1 in
9.7 in
7.3 in
5.5 in
16.2 in
Left Rear Wall
Hole 2.5 in
Right Rear Wall
Hole 2.5 in
Indoor Unit
Outline
1.5 in
1.5 in
11.2 in
1.85 in
1.85 in
1.7 in
4.2 in
Left Rear Wall
Hole 2.5 in
Right Rear Wall
Hole 2.5 in
Indoor Unit
Outline
11.88 in
1.4 in
1.4 in
1.85 in
1.85 in
11.2 in
9.57 in
1.7 in
9.5 in
5.6 in
3.9 in
37.7 in
Left Rear Wall
Hole 2.5 in
Right Rear Wall
Hole 2.5 in
12.79 in
2.16 in
1.85 in
1.85 in
2.16 in
10.4 in
40.85 in
8.6 in
13.5 in
11.8 in
1.77 in
1.77 in
22 in
HME030356N
HME030358N
HME030359N
HME030357N/HME030363N/HME030364N
To Next Page
Loading...
