Homelite 150 User Manual

I
r
E
t
h.'.
F.
DAILY
ATTENTTON
n?Ki!;,ban
At the end
of each
day
ol operation,
remove
the chain
and
guide
bar. Clean
the sawdust
from the
guide
bar
mounting
pad,
the
clutch area
and
the clutch
cover.
Clean
out'the
oil discharge
hole
in the
guide
bar
mounting
pad.
Clean
the
Chain
groove
in the
guide
bar.
The chain
should
be liled and
cleaned.
Then the
chain
should
be immersed
in
a
can
of light
oil until
ready
for the
next use.
Sprocket
nose
guide
bars
must be
lubricated while
siill warm
lrom use, at
the end of each
day of
cutting.
Using
needle
nose of
Lube Gun
#24258
filled
with
HOMELITE
ALL-TEMP
Multi-Purpose
grease'
pump
grease
into the
sprocket
nose bearing
through_ the
-mall
grease
hole
in the side of
the bar
nose. Keep
pumping
until the
dirty
grease
is forced out
and
fresh
1.
grease
oozes out
of the nose,
This removes sawdust,
dirt and
moisture
trom the bearing.
ll
bar
is lubricated
when cold,
the old
grease
may not come out.
BAR NosE sHouLD stLL
BE *ARM
*HEN
/
NOSE IS
LUBRICATED
1,,
[/
\,
3.
LUBE
HOLE
swlTcH
THROTTLE
TRIGGER
LATCH
PULL BACK
TO
LATCH
TRIGGER
FOR
STARTING.
DEPRESS
AND
LET GO
OF
TR]GGER
TO
UNLATCH,
DEPRESS
TRIGGER
ALL
THE WAY WHEN
CUTTING
WOOD
A sprocket
nose
bearing
is
good
as
long as it
turns
freeiy with
no roughness
or binding.
However, it can be
replaced
with a
new sprocket
nose assembly
(Ho[,lELlTE
A--67050)
whenever
necessary. Both
the chain
drive and
nose sprockets
should
be
replaced
whenever a
neu
chain
is being installed.
NUTS SHOULD
BE FINGER.TIGHT
DURING
TENSIONING
AND
TIGHTENED
AFTERWARD
HOLD
UP
BAR NOSE
ADJUST
TENSION
SLIDE
CHOKE
ALL
THE WAY
BACK
TO
START
COLD
ENGINE.
PUSH BACK
HALF.
WAY AFTER
ENGINE
FIRES. PUSH ALL
THE
WAY
FORWARD
AS SOON
AS
ENGINE
STARTS
AND RUNS.

Homelite 150 Specifications

General

Brand	Homelite
Model	150
Category	Chainsaw
Language	English