x10x10
2
3
VI
4
VI
4
1
2
3
VI
66
VI
1
2
3
1
1
2
3
4
STARTING A COLD ENGINE
1. Lay the product on the ground. Press the
primer bulb 10 times.
NOTE: After the 7th press, the fuel
should be visible in the primer bulb. If
not, continue pressing until the fuel is
visible.
2. Set the choke lever to choke
position. Squeeze the throttle trigger
completely position and pull the starter
grip until the engine attempts to start.
Do not pull the starter grip more than 4
times.
3. Set the choke lever to
position.
Squeeze the throttle trigger completely
and pull the starter grip until the engine
starts. Do not pull the starter grip more
than 6 times.
NOTE: If the engine does not start,
repeat the procedure again from setting
the choke lever to choke
position.
4. Allow the engine to run for 10 seconds,
then set the choke lever to
position.
15
To Next Page
Loading...
Need help?
General
