To Next PageTo Next PageWhat to do if HomeSeer HS-FLS100+ Accessories Z-Wave controller cannot communicate with the unit?
If your HomeSeer Accessories Z-Wave controller can't communicate with the unit, it might be out of range. Try these steps: 1. Move the controller closer to the unit. 2. Install a Z-Wave repeater, like smart plugs or other AC devices that function as repeaters.
Why does my HomeSeer Accessories floodlight remain on?
If your HomeSeer Accessories floodlight remains on, it could be due to the PIR detector being triggered by an unknown heat source. Here's what you can do: 1. Check the time setting. 2. Cover the PIR detector with black insulating tape. If the floodlight turns off after the timer expires, it indicates that the PIR detector is sensing a moving heat source. This could be a radiator, heater, boiler outlet, open window, open exterior door, or moving branches or bushes retaining heat from the daytime.
What to do if HomeSeer HS-FLS100+ Accessories floodlight flashes on and off?
If your HomeSeer Accessories floodlight flashes on and off, the unit's lux sensor may be triggered by reflected light. Try changing the angle and direction of the lamps.
What to do if I cannot carry out inclusion and association with HomeSeer HS-FLS100+?
If you cannot carry out inclusion and association with your HomeSeer Accessories floodlight, it may already be paired to another Z-Wave Controller. Perform a factory reset to resolve this issue.
How to fix HomeSeer Accessories floodlight that does not turn on after power is connected?
If the HomeSeer Accessories floodlight does not turn on for 5 seconds after connecting the power, it could be due to an improper power connection. Check if the wall switch is on, confirm the wiring is correct, and inspect the supply breaker or fuse.
General| Brand | HomeSeer |
|---|---|
| Model | HS-FLS100+ |
| Category | Accessories |
| Language | English |
General description of the HS-FLS100+ PIR module and its capabilities.
Using the HS-FLS100+ as a conventional motion-activated floodlight sensor.
Integrating the HS-FLS100+ into a smart home system for advanced control.
Utilizing the HS-FLS100+ solely as an outdoor motion and LUX sensor.
Support for the S2 security protocol for encrypted Z-Wave Plus messages.
Essential safety guidelines and warnings before and during installation.
Step-by-step instructions for safely removing an existing floodlight fixture.
Guide for removing an old motion sensor if one is present during installation.
Detailed instructions for wiring the HS-FLS100+ into the floodlight fixture.
Procedures for reassembling the floodlight fixture after wiring.
Performing a walk test to verify PIR detector coverage and sensitivity.
Manual adjustment of floodlight ON time and LUX sensitivity settings.
Process for automatic inclusion of the device into a Z-Wave network.
Understanding Z-Wave association groups and command classes for control.
Overview of notifications sent by the unit upon various events.
Details on Z-Wave Plus information roles and icons for network integration.
Detailed parameters for configuring PIR trigger off period and Lux sensor threshold.
Solutions for common problems like floodlight not turning on or inclusion failures.
Step-by-step guide for manually setting the Lux level for floodlight activation.
Procedures for manually adding or removing the unit from a Z-Wave network.
Technical specifications including dimensions, detection area, and operating temperature.
