If the outboard motor was submerged
5/5
STEP 4 – Attempt to start the engine
11. Install the engine cover.
If the outboard motor was running when it became
submerged, there may be mechanical damage, such
as bent connecting rods. If the engine binds when
cranked, do not attempt to run the outboard motor
until it has been repaired.
NOTICE
12. Attempt to start the engine.
- If the engine fails to start, remove the spark
plugs, clean and dry the electrodes, then
reinstall the spark plugs and attempt to start the
engine again.
- If used engine oil showed signs of water
contamination, then a second engine oil change
should be performed after running the engine
for 1/2 hour.
- If the engine starts and no mechanical damage
is evident, continue to run the engine for 1/2
hour or longer (ensure the water level is at least
100 mm above the anticavitation plate).
Take the outboard motor to your dealer as soon as
possible.
To Next Page