EasyManuals Logo

Honda BF225D User Manual

Honda BF225D
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
128
MAINTENANCE
8. Align the aligning mark as shown
in the figure, when installing the
suspension strap on the fuel filter
with water separator.
9. Prime the engine using the priming
bulb (see page 67). Check for fuel
leaks. Repair any fuel leaks if
necessary.
If the buzzer sounds, water or
sediment accumulation is found to be
caused by excessive water or
sediment accumulated in the fuel
filter, inspect the fuel tank. Clean the
fuel tank if necessary.
EMISSION CONTROL SYSTEM
The combustion process produces
carbon monoxide and hydrocarbons.
Control of hydrocarbons is very
important because under certain
conditions, they react to form
photochemical smog when subjected
to sunlight. Carbon monoxide dose
not react in the same way, but it is
toxic.
Problems that May Affect Outboard
Motor Emissions
If you are aware of any of the
following symptoms, have the
outboard motor inspected and
repaired by your authorized Honda
Dealer:
1. Hard starting or stalling after
starting
2. Rough idle
3. Misfiring or backfiring during
acceleration
4. Poor performance (driveability)
and poor fuel economy
ALIGNING MARK
SUSPENSION STRAP
42ZVL600.book 128 ページ 2018年7月19日 木曜日 午前9時6分

Table of Contents

Other manuals for Honda BF225D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honda BF225D and is the answer not in the manual?

Honda BF225D Specifications

General IconGeneral
BrandHonda
ModelBF225D
CategoryOutboard Motor
LanguageEnglish

Related product manuals