-------1.
SE
RVI
CE
PRECAU
TI
ONS--------
I. Always replace gaskets, 0-ri.ngs and coHCr pins whenever reassembling.
2.
When
tightening bolts
or
nuts for which sequence
is
not
specified, begin
on
center
or
larger diameter bolts and
tighten
them
in
a
criss-eross
pattern
t?
specified
torque
in
two
or
more
steps if necessary.
3.
Use
genuine HONOA parts and lubricants
or
those recommended
by
HONDA.
4.
Use
special service.tool where use
of
such a tool is specified.
5.
Clean engine parts in
or
with cleaning solvent upon disassembly. Apply lubricant
to
their sliding surfaces when
reassembling.
6.
Coat
or
pack parts with grease where so specified.
7. Upon assembling, check every possible part for proper installation and movemem
or
operation.
8. A joint work
of
more than two persons must
be
carried
out
with mutual safety attention paid.
NOTE
:
The
procedures
for
reassembling the engine
and
frame parts are, as a rule,
not
described. Follow
the
reverse
of
disassembling
procedures
carefully
observing
the
titles
"Reassembly
points"
in
each
section.
am
shaft
Cam chain tensioner
-
Cam
chain guide
roller
Primary
drive
gear
Oil
filter
Gear
shift
Clutch
Countershaft
Mainshaft
Kick
starter
To Next Page
Loading...
Need help?
General
