►
CB200T ADDENDUM SHEET
4. SIDE STAND
The
side stand was changed
to
a new type with a shock
absorbing rubber pad.
Inspection
1. Check !he entire stand assembly (side stand bar, bracket
and rubber pad)
for
installation, deformation
or
other-
wise
excessive
damage
.
2. Check the spring
for
freedom from damage
or
other
defects.
3. Check !he side stand for proper return operation:
a.
With tbc side stand applied, raise
!he
stand
off
the
ground
by
using the main stand.
b.
Attach a spring scale
to
the lower
end
of
the stand
and measure the force with which the stand
is
returned
to
its original position.
c. The stand condition
is
correct
if
the measurement
falls
within 2-3kg
(4.4~.6
lbs.)
.
If
the stand requires force exceeding the above limit,
thls might
be
due
to
neglected lubrication, over-
tightened stand pivot bolt, worn stand bar
or
bracket,
or
otherwise excessive tension. Replace as necessary.
4. Check the rubber pad for deterioration
or
wear.
When
!he rubber pad wear
is
excessive so
that
it
is
worn
down
to
the wear line,
replaa
it
with a new
one
.
Rubber
pod
replacement
1.
Remove the
6mm
bolt; separate the rubber pad from
!he bracket at the side stand.
2.
After making sure the coUar
is
installed,
put
a new
rubber pad in place in !he bracket with the
ar
row
mark
out.
NOTE:
Use
rubber
pad
having
the
mark
"OVER
260
I bs
ONLY".
3. Secure the rubber pad with Ille 6mm bolt.
Fig.
T- 4
(I)
(3)
(5)
Fig.
T-S
(I)
(2)
GOOD
Fig.
T- 6 {
l)
Fig.
T- 7 (
1)
(2)
Side stand
bar
(2)
Rubber pad
(4)
Side
stand
pivot bolt
Side stand bar
Spring
scale
Wear
line
Rubber pad
Collar
Spring
6mmbolt
91
To Next Page
