Honda CTX700A - Removing & Installing Body Components; Seat; Seat Installation

64
Maintenance
Removing & Installing Body Components
Seat
❙
Removal
1. Insert the ignition key into the seat lock,
and turn it clockwise.
2. Pull the seat back and up.
❙
Installation
1. Insert the front and rear prongs into the
front and rear stays on the frame.
2. Push forward and down on the rear of the
seat until it locks in place. Make sure that
the seat is locked securely in position by
pulling it up lightly.
The seat locks automatically when closed.
Take care not to lock your key in the under
seat compartment.
Prongs
Front stay
Rear stays
Seat
Seat lock
Ignition key
14 CTX700-32MJF8000.book 64 ページ ２０１３年５月９日 木曜日 午後９時５９分