Honda NM4 2018 - Removing & Installing Body Components; Battery

Removing & Installing Body Components
Battery
#
Removal
Make sure the ignition switch is in the OFF
position.
1.
Remove the front seat. 2 P. 79
2.
Unhook the rubber strap.
3.
Disconnect the negative - terminal from
the battery.
4. Disconnect the positive + terminal from
the battery.
5. Remove the battery taking care not to
drop the terminal nuts.
#
Installation
Install the parts in the reverse order of
removal. Always connect the positive +
terminal first. Make sure that bolts and nuts
are tight.
Make sure the clock information is correct
after the battery is reconnected. 2 P. 29
For proper handling of the battery, see
“Maintenance Fundamentals.” 2 P. 64
“Battery Goes Dead.” 2 P. 122
Maintenance
76
Rubber strap
Positive terminalNegative terminal
Battery