107
uuIndicatorsuDriver Information Interface Warning and Information Messages
Continued
Message Condition Explanation
• Appears when you try to change the gear position
without releasing your foot off the accelerator pedal.
• Release your foot off the accelerator pedal, then select
a shift button.
• Appears when the (P button is pressed while the
vehicle is moving.
• Appears if you change the gear position to
(R while
the vehicle is moving forward, or to (D while the
vehicle is reversing.
• Make sure that the vehicle comes to a stop before
operating the select button.
• Appears when you set the power mode to ON
without fastening the driver’s seat belt.
• Appears when you change the gear position after
(P has been automatically selected with the driver’s
door open, the driver’s seat belt unfastened, then
the brake pedal is released.
• Fasten the seat belt properly before you start to drive.
2 Shift Operation P. 534
• Appears when you press the (P button but it is not
engaged due to low ATF temperature.
• Depress the brake pedal until this message disappear.
• Appears when depressing the accelerator pedal
while the gear position is in (N.
• Remove your foot from the accelerator pedal. When
driving, depress the brake pedal and change the gear
position.
21 PILOT-31TG76500.book 107 ページ ２０２０年３月１８日 水曜日 午後４時３８分
To Next Page
Loading...
