Honda TRX500FPM - Swingarm Installation

REAR WHEEUSUSPENSION
INSTALLATION
Pack molybdenum disulfide grease into the seal lip r--- ----- -------- --
cavity of each new dust seal Pl. ~~ , ~", ~
Install the dust seals until the depth from the outer ...... ~ lllliil'
'u.".", mm. 1)\ 11 ~ {11 I
Install the pivot collars [11 in position as shown.
Install the universal joint guard [2] with new bolts [3] and
tighten them to the specified torque.
TORQUE : 10 N'm (1 .0 kgf 'm, 7 IbHt)
l
1 mm
(4 places)
Right side:
Left side:
~\f
{21
{11
111
Insert the bolts from Install the swingarm [1 1 with new pivot bolls [2J and nuts ~========= =~=====:::;:: ;
the outside. (3], and tighten them to the specified torque.
17-10
TORQUE : 118 N'm (12.0 kgf 'm , 87 IbHt )
Install
the breather hose [4J into the damp [5].
Install the following:
- final gear assemb ly (p age 20-22)
- mudguards (page 2-6)
111