5
Change mode
Display sleep
Change temperature
Warmer Cooler
Symbol Mode
Heat mode - the ductless unit warms the space to the
temperature shown on the controller.
Cool mode - the ductless unit cools the space to the
temperature shown on the controller.
[screen is
blank]
Off mode - the ductless unit is turned off
Room temperature
Any time the controller is not being interacted with, the current room
temperature is displayed on screen.
Viewing set temperature
Be sure the controller is not in Display sleep, then press
+
or
-
once to
view the current set temperature. The set temperature will “pulse” on
screen. After a short period of time the screen will change to display the
room temperature.
Change temperature
1. Be sure the controller is not in Display sleep, then press
+
or
-
more
than once to change the set temperature so it is higher or lower in the
current mode.
2. Stop pressing
+
or
-
when you reach the temperature you want.
3. The screen will pulse and then return to the room temperature
display.
1. Be sure the controller is not in Display sleep, then press
o to change
the system mode.
2. Stop pressing
o when you reach the mode you want.
The ductless unit will beep when it gets a command from the controller.
The controller goes into Display sleep (the screen is dim) after 45
seconds of inactivity. Press
o to wake up the controller. This button push
does not change temperature or settings.
To Next Page
Loading...
Need help?
General
